How much does electrical panel upgrade cost in Inglewood?
In Inglewood, CA, an electrical panel upgrade typically costs $2,450–$4,900 to upgrade to 200-amp service. Upgrading an electrical panel boosts your home's capacity for modern loads like EV chargers, heat pumps, and additions. Cost depends on the new amperage and whether the service entrance also needs work.
Get free electrical panel upgrade quotes from vetted Inglewood pros
Compare a few local quotes before you commit — prices for the same job vary widely between contractors.
Compare local quotes →Cost by scope in Inglewood
These ranges are adjusted for Inglewood labor and permit costs:
| Type | Inglewood price range |
|---|---|
| Panel replacement (same amperage) | $1,600–$3,050 |
| Upgrade to 200-amp service | $2,450–$4,900 |
| Upgrade + new service mast/meter | $3,650–$7,300 |
Estimates for 2026; actual quotes vary by home, scope, and contractor. Always get written bids.
What drives electrical panel upgrade cost
- Target amperage: Going from 100 to 200 amps (or higher) means a bigger panel and often a new service entrance.
- Panel location & access: A cramped or far-from-the-meter location makes the job slower and pricier.
- Service entrance: Upgrading the mast, meter, and utility connection adds cost beyond the panel itself.
- Code corrections: Older homes often need grounding, bonding, or circuit fixes to pass inspection.
- Permits & labor: An electrical permit, utility coordination, and licensed-electrician rates drive much of the total.
Inglewood cost factors
Coastal Southern California pairs a mild, equipment-friendly climate with a high cost of living, strict California permitting and energy codes, and seismic requirements. Salt air near the coast can accelerate corrosion on rooftop HVAC and metal roofing, and labor runs above the national average.
Frequently asked questions
How much does an electrical panel upgrade cost in Inglewood?
Upgrading to a 200-amp panel in Inglewood typically costs $2,450–$4,900. A simple same-amperage replacement is lower; adding a new service mast and meter runs higher.
What are the signs I need a panel upgrade?
Frequently tripped breakers, a fuse box, flickering lights, a panel under 100 amps, or plans for an EV charger, heat pump, or addition all point to an upgrade.
How long does a panel upgrade take?
Most panel upgrades are a 4–8 hour job, plus a short utility disconnect and an inspection. Service-entrance work can extend it.
Do I need a permit to replace an electrical panel?
Yes — panel work requires an electrical permit and inspection almost everywhere, and should only be done by a licensed electrician.
Get matched with vetted Inglewood electrical panel upgrade pros and compare free quotes.
Compare local quotes →Electrical Panel Upgrade costs in other cities
Sacramento, San Jose, Fresno, San Diego, Phoenix, Los Angeles, Austin, Dallas, Houston, Denver, Atlanta, Chicago
Other project costs in Inglewood
- Roof Replacement in Inglewood
- Hvac Installation in Inglewood
- Kitchen Remodel in Inglewood
- Water Heater Replacement in Inglewood
- Bathroom Remodel in Inglewood
- Window Replacement in Inglewood
- Interior Painting in Inglewood
- Flooring Installation in Inglewood
- Solar Panel Installation in Inglewood
- Fence Installation in Inglewood
- Garage Door Replacement in Inglewood
Published 2026-06-16. Cost ranges are general 2026 estimates for guidance only, not quotes. Get written bids from licensed local contractors.